

![]() View Full-Size Image |
DDR3 ECC REG RAM 4GB PC1333 (NEHLAM) |
|
| ( Kingston ) |
||
|
Rs7,455
|
|
|
Features This document describes Value RAM's 256M x 64-bit 2GB (2048MB) DDR3-1333 CL9 SDRAM (Synchronous DRAM) Memory Module based on sixteen 128M x 8-bit DDR3-1333 FBGA components. The SPD is programmed to JEDEC Standard latency 1333Mhz timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V JEDEC standard 1.5V 0.075V Power Supply VDDQ = 1.5V 0.075V 667MHz fCK for 1333Mb/sec/pin 8 independent internal bank Programmable CAS Latency: 5,6,7,8,9,10 Posted CAS Programmable Additive Latency: 0, CL - 2, or CL - 1 clock Programmable CAS Write Latency(CWL) = 9(DDR3-1333) 8-bit pre-fetch Burst Length: 8 (Interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] Bi-directional Differential Data Strobe Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm 1%) On Die Termination using ODT pin Average Refresh Period 7.8us at lower then TCASE 85C, 3.9us at 85C < TCASE . 95C Asynchronous Reset 1066Mbps CL7 doesnt have backward compatibility with 800Mbps CL5 PCB : Height 1.180 (30.00mm), double sided component Performance CL(IDD) 9 cycles Row Cycle Time (tRCmin) 49.5ns (min.) Refresh to Active/Refresh Command Time (tRFCmin) 90ns Row Active Time (tRASmin) 36ns (min.) Power TBD W (operating) UL Rating 94 V - 0 Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C |
||
|
|
||
| |
||
| |
||
List All Products |
|
| Lost Password? | |
| Forgot your username? | |
| No account yet? Register | |
|
|